cảm biến áp suất Pressure Sensor PCB 123B22

cảm biến áp suất Pressure Sensor  PCB  123B22

cảm biến áp suất Pressure Sensor PCB 123B22

Rocket motor ICP® pressure sensor 3000 psi 1mV/psi Helium bleed water-cooled (replaceable tubes)

This new sensor replaces Model 123A22. Model 123B22 features water cooling tubes that may be replaced on site without returning the entire sensor back to PCB for service.

Measurement Range: 3000 psi (20685 kPa)

Sensitivity: (±15%)1.0 mV/psi (0.145 mV/kPa)

Low Frequency Response: (-5%)0.001 Hz

Resonant Frequency: >=25 kHz (>=25 kHz)

Electrical Connector: Integral Cable

Weight: 4.59 oz (130 gm)

  • 123B22
  • Liên hệ
  • 939
  • Thông tin sản phẩm
  • Bình luận

Specification Notes


[1] Zero-based, least-squares, straight line method.
[2] Typical.
[3] With helium flow.
[4] Applies to internal amplifer, not to external housing.
[5] See PCB Declaration of Conformance PS023 for details.

  ENGLISH: SI:  
PERFORMANCE
Measurement Range (for ± 3V output) 3000 psi 20685 kPa  
Sensitivity (±15 %) 1.0 mV/psi 0.145 mV/kPa  
Maximum Pressure 5000 psi 34475 kPa  
Resolution 0.1 psi 0.689 kPa [2]
Resonant Frequency ≥25 kHz ≥25 kHz [3]
Rise Time (Reflected) ≤20 µ sec ≤20 µ sec [3]
Low Frequency Response (-5 %) 0.001 Hz 0.001 Hz  
Non-Linearity ≤1.0 % FS ≤1.0 % FS [1]
ENVIRONMENTAL
Acceleration Sensitivity ≤0.002 psi/g ≤0.0014 kPa/(m/s²)  
Temperature Range (Operating) -100 to +250 °F -73 to +121 °C [4]
Temperature Coefficient of Sensitivity ≤0.03 %/°F ≤0.054 %/°C  
Maximum Flash Temperature 10000 °F 5538 °C  
Maximum Vibration 2000 g pk 19600 m/s² pk  
Maximum Shock 10000 g pk 98070 m/s² pk  
ELECTRICAL
Output Polarity (Positive Pressure) Positive Positive  
Discharge Time Constant (at room temp) ≥500 sec ≥500 sec  
Excitation Voltage 20 to 30 VDC 20 to 30 VDC  
Constant Current Excitation 2 to 20 mA 2 to 20 mA  
Output Impedance ≤100 Ohm ≤100 Ohm  
Output Bias Voltage 8 to 12 VDC 8 to 12 VDC  
PHYSICAL
Housing Material 17-4 Stainless Steel 17-4 Stainless Steel  
Diaphragm Invar Invar  
Sealing Epoxy Epoxy  
Electrical Connector Integral Cable Integral Cable  
Weight (without cable) 4.59 oz 130 gm  
Helium Flow Rate (at 1,500 psi) 40 scf/hr 1.13 m³/hr  
Water Flow Rate (at 50 psi) 1.2 gal/min 4.5 L/min  
Cable Length 4 ft 1.2 m  

* All specifications are at room temperature unless otherwise specified.

Accessories


 

     
Supplied
070A08 Cable adaptor (10-32 jack to BNC jack) 1
065A72 Replacment cooling tubes, set of 2 each, with o-rings, for series 123B 2
065A15 Seal, 0.624" OD x 0.553" ID x 0.080" thk, brass (for Series M121Axx & 123A) 3
Sản phẩm cùng loại