Cảm biến tương phản KTM Prime SICK Contrast sensors KTM Prime Type: KTM-WP11172P Part no.: 1082138
Type: KTM-WP11172P Part no.: 1082138
Features
Dimensions (W x H x D) 12 mm x 31.5 mm x 21 mm
Sensing distance 12.5 mm
Sensing distance tolerance ± 3 mm
Housing design (light emission) Small
Light source LED, RGB 1)
Wave length 470 nm, 525 nm, 625 nm
Light emission Long side of housing
Light spot size 1.5 mm x 6.5 mm
Light spot direction Vertical 2)
Receiving filters None
Adjustment Teach-in button
Teach-in mode
2-point teach-in static/dynamic + proximity to mark
ET: Teach-in static
1) Average service life: 100,000 h at TU = +25 °C.
2) In relation to long side of housing.
Mechanics/electronics
Supply voltage 12 V DC ... 24 V DC 1)
Ripple ≤ 5 Vpp 2)
Current consumption < 50 mA 3)
Switching frequency 15 kHz 4)
Response time 32 µs 5)
Jitter 15 µs
Switching output PNP
Switching output (voltage) PNP: HIGH = UV ≤ 2 V / LOW approx. 0 V
Switching mode Light/dark switching
Output current Imax. 50 mA 6)
Input, static teach-in (ET)
PNP: Teach: U = 10,8 V ... < UV
PNP: Run: U < 2 V or open
Retention time (ET) 28 ms, non-volatile memory
Time delay None
Connection type Cable with M12 male connector, 4-pin, 0.2 m
Protection class III
Circuit protection
UV connections, reverse polarity protected
Output Q short-circuit protected
Interference pulse suppression
Enclosure rating IP67
Weight 20 g
Housing material Plastic, ABS
Optics material Plastic, PMMA
Indication
LED indicator green: power on
LED indicator, yellow: Status switching output Q
1) Limit values: DC 12 V (–10 %) ... DC 24 V (+20 %). Operation in short-circuit protected network max. 8 A.
2) May not exceed or fall below Uv tolerances.
3) Without load.
4) With light/dark ratio 1:1.
5) Signal transit time with resistive load.
6) Total current of all Outputs.